There are a number of reasons you might need to install or replace a toilet. Maybe your old toilet is worn out and needs to be replaced. Or maybe you’re renovating your bathroom and want to install a new toilet.
Whatever the reason, installing or replacing a toilet is a relatively easy job that most Dyers can handle. In this blog post, we’ll show you how to do it.
What do you need: Tools and materials for the job?
To install or replace a toilet, you’ll need the following tools and materials:
- Toilet plunger
- Toilet auger
- Putty knife
- Hacksaw
- Hammer
- Screwdriver
- Drill
- Tape measure
- Level
- Utility knife
You’ll also need the following materials:
- New toilet
- Toilet bolts
- Wax ring
- Flange
- Supply line
- Teflon tape
How to do it: Step-by-step instructions for installing or replacing a toilet?
Installing or replacing a toilet is a relatively easy job. Follow these steps and you’ll have your new toilet up and running in no time. handyman services in Cherry Hills Village, CO have also more steps for installing or replacing a toilet.
Step 1: Turn off the water supply to the toilet.
Step 2: Flush the toilet to empty the tank.
Step 3: Disconnect the supply line from the toilet.
Step 4: Remove the toilet bolts that hold the toilet to the floor.
Step 5: Lift the toilet off the floor and remove it from the room.
Step 6: Clean the floor where the toilet was installed.
Step 7: Install the new wax ring on the bottom of the toilet.
Step 8: Position the toilet over the hole in the floor and align the bolt holes with the holes in the flange.
Step 9: Install the toilet bolts and tighten them to secure the toilet to the floor.
Step 10: Reconnect the supply line to the toilet.
Step 11: Turn on the water supply to the toilet.
Step 12: Flush the toilet to fill the tank.
Conclusion:
Installing or replacing a toilet is a relatively easy job that most Dyers can handle. In this blog post, we’ve shown you how to do it. Just follow the steps outlined above and you’ll have your new toilet up and running in no time.
